AMT Datasouth Accel-7450 Manual do Utilizador descarregar pdf (Página 11)

ACCEL-7450

HA GAP ADJ UP

9. Press the ENTER key and verify the print gap is electronically positioned. Print

gap is established when the printhead moves down.

10. Press the ENTER key a second time to print “H” pattern. Paper will advance

forward.

11. Press the EJECT key to remove paper.

12. Press the HIGH IMPACT key to exit menu and save settings.

13. Load cut sheet paper and start self-test print (LF key + Power Up).

14. Press the ONLINE key to stop test print. Turn the printer power OFF and

manually remove paper by pulling on trailing edge. Note: moving the printhead

carrier by hand will adversely change the gap measurement in the next step.

15. Using a .004” feeler gauge check the gap between the head carrier foot and

platen. Specification: .004” fits, .006” does not fit.

NOTE: If .004” print gap has been achieved skip steps 16 through 22.

Head Carrier Foot

Insert feeler gauge between

metal foot and platen

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Sem comentários

AMT Datasouth Accel-7450 Manual do Utilizador Página 11