AMT Datasouth Fastmark M1 Guia do Utilizador descarregar pdf (Página 230)

Internationalizing Printing

l Supported Printers in Loftware: Printronix 5204, 5206, 5208, 5304, 5306, 5308, IBM_4400-004

(203 dpi) IBM_4400-004 (300 dpi), IBM_4400-006 (203 dpi), IBM_4400-006 (300 dpi), IBM_4400-

008 (203 dpi), IBM_4400-008 (300 dpi).

Note: IBM Printers are OEM Printronix.

l Fonts Added to the Properties Box: “TwoByte” – This font selection is used for all of the DBCS

settings. The printer includes the DBCS Font itself; there is no ability or need to differentiate

between them in Design Mode.

l PSO DBCS Option – This allows you the ability to set a default double-byte character set for use

ONLY in “test print” mode in Loftware Design. LLM Design generates appropriate test print data

for the printer firmware you are using.

Note: Loftware does not convert the data from UTF-8 to DBCS at this time.

SATO

The following fonts have been added to the SATO driver for Loftware:

l Kanji 16x16 dot, JIS data

l Kanji 24x24 dot, JIS data

l Kanji 16x16 dot, Shift-JIS data

l Kanji 24x24 dot, Shift-JIS data

These fonts are bitmapped, meaning that representative glyphs reside in the SATO printer and may be

selected as you would select any other font in the Properties box. Remember to enable the use of DBCS

under Options | Preferences in Loftware Design mode.

Since SATO only supports the previously mentioned double-byte fonts, they may be chosen under the

fonts section rather than in Device Specific Options.

Note: The choice of JIS and Shift-JIS is included in the font (rather than on the PSO/LSO) because Japanese is

the only DBCS language SATO supports, and only JIS and Shift-JIS are supported. When one of these fonts is

selected, the Language Properties Wizard opens. Also, the SATO driver does not currently use the "character

set" option from the PSO at all, as the other printers do.

Note: The SATO manual also lists a 22x22 Kanji JIS font, but in testing with a CL408e this does not work so it

has not been enabled through Loftware.

Hardware

The SATO fonts are supplied on a small printed-circuit board (PCB) containing an EPROM chip. This

PCB is swapped for one already in the printer.

Other Properties

l Bold - Bold property may be set YES/NO. (The SATO manual refers to this as “emphasis.”)

l Spacing - Spacing property may be set to “Smoothing” or “Non-Smoothing.”

The following SATO printers have the Kanji fonts available in Loftware:

Loftware Label Manager Version 10.1.1 User's Guide

230

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 531 532

Sem comentários

AMT Datasouth Fastmark M1 Guia do Utilizador Página 230