AMT Datasouth Fastmark M1 Guia do Utilizador descarregar pdf (Página 453)

Paxar (Monarch) MPCL1 Printers

Forms Control Section

Old Firmware

Does not send new firmware options if

checked. If you are having difficulty

communicating with the printer, try selecting

this option. By choosing this option, you

disable status checking and other commands

that are only supported in newer versions of the

printer firmware. If using this option allows you

to print, you may wish to consider purchasing a

printer firmware upgrade. After your printer

firmware upgrade is installed, you should

uncheck this option.

Only Resend Fields that have

changed

When checked, only the data that has been

changed is re sent for printing.

Note: The Paxar 9403, 9805, and 9856 printers do not support backfeed.

Backfeed Control Section

Use Backfeed Control to enable or disable the backfeed option, set the dispense position and the backfeed

distance.Backfeed works by advancing each printed label to the desired dispense position.Once that label is

removed, the next label to be printed is backed up underneath the printhead.In continuous mode, only the last

label in the batch is advanced to the dispense position.You may need to adjust the dispense position to allow labels

to be removed, die cut labels to be removed easily, or to prevent them from falling off.

The dispense position and backfeed distance are optional parameters and do not have to be specified.However,

they allow for greater precision when positioning the supply.You cannot change the backfeed distance while the

printer is active.

Dispense Position

Adjusts the stopping point of the label. 50 to 200 dots

(default 65 dots).

Backfeed Distance

Amount to move label backwards. 10 to 200 dots

(default 65 dots). Cannot be greater than the dispense

position.

Backfeed

Extended Backfeed

Disable Backfeed

The backfeed distance should equal the dispense position. An exception is if you are tearing instead of peeling.

Then, the backfeed distance must be 30 dots (.150 inches) less than the dispense position. However, the result is a

30 dot non-print zone on your supply.

Font Style Section

Opaque

The font and its envelope are opaque and blot

out any lines or other fields that it overlaps.

Transparent

The font and its envelope are transparent, and

any lines or other fields that it overlaps are

visible.

Loftware LabelManager Version 10.1.1 User's Guide

453

1 2 ... 448 449 450 451 452 453 454 455 456 457 458 ... 531 532

Comentários a estes Manuais

Sem comentários

AMT Datasouth Fastmark M1 Guia do Utilizador Página 453

Comentários a estes Manuais