AMT Datasouth Fastmark M1 Guia do Utilizador descarregar pdf (Página 407)

Datamax-O'NeilPrinters

Label Options Section

Supply Type

n Die Cut - Stock that has gaps between each label.

n Continuous - No gaps, notches, or perforations between

labels.

n Mark Stock - Black mark found opposite print side.

Buffer Mode

n Double - Selecting the double buffer mode instructs the

printer to erase and format only incremental fields that have

changed.

n Single - Selecting single buffer mode instructs the printer to

erase and format both incremental fields and the rest of the

label format.

This feature is only active when the labels being printed are less

than half the maximum size of the printer’s print buffer.

Ribbon Saver

This command turns the ribbon saver feature on in supported

printers. The command is ignored by printers that do not support

this feature. When the ribbon saver feature is turned on, the

ribbon saver automatically lifts when the minimum amount of

white space is exceeded.

Forms Control Section

Note: Settings for Tear Off, Form Edge, and Label Gap are in dots. Use the dots per

inch (dpi) for your printer to find the proper value.Datamax settings increment each

1/100 of an inch.

Present Distance

This specifies an additional amount to advance the label after

printing.

Tear Off (Label

Retract)

The Tear Off control enables the label retract feature of the

printer.The printer advances the label “tear off” dots after the

label is printed so the label can be torn off.It automatically

retracts the label back to the proper start position before printing

the next label.

The length should be set longer than the form edge.

Form Edge (Top of

Form)

The Form Edge control determines where printing begins on your

label. If you want the printer to print nearer to the leading edge

of the label, decrease the form edge offset. If you want to move

the start of print position away from the leading edge of the label

(into the body of the label), increase the form edge offset.

Note: In order for the form edge settings to take effect, you must download the

format 2 or 3 times. This is an idiosyncrasy of Datamax printers.

Label Gap

For continuous stock, this setting is used to add space between

printed labels. The settings available are in increments of 1/100 of

an inch.

Loftware LabelManager Version 10.1.1 User's Guide

407

1 2 ... 402 403 404 405 406 407 408 409 410 411 412 ... 531 532

Comentários a estes Manuais

Sem comentários

AMT Datasouth Fastmark M1 Guia do Utilizador Página 407

Comentários a estes Manuais