AMT Datasouth Fastmark M1 Guia do Utilizador descarregar pdf (Página 427)

Intermec and UBI Printers

Intermec Label Specific Options

Label Specific Options (LSOs) can be accessed when you click Label Options from the Label Setup and

Properties dialog (F5).

Option Description

Format

Number

Specifies the areas of RAM in which the label format is to be stored.

Print Speed

The range of available print speeds varies with the selected printer type. Note that the

printer may user a slower print speed than you specify in order to maintain print quality.

Certain Intermec printers allow print speeds in .5 IPS increments.

Head

Temperature

Head Temperature allows you to control the darkness of the print.Zero (0) is nominal,

setting the temperature higher than 10 causes the label to print darker.Settings lower

than 10 cause the label to print lighter.

Media

Sensitivity

This number specifies the amount of heat required by the printhead to image a label.

Look at the sensitivity label located on the label stock, and check the last three digits of

the 15-digit number. These three numbers stamped on the label give you the number

you use for this setting.

Cut Interval

This value is used to determine how many labels to print before cutting. This option is

only used when “Use Label Specific Options Cut Interval” is enabled.

Note: Loftware Label Manager defaults to using the Cut Immediate command

(<SO>) in conjunction with disabling the cutter (<SI>c0) per Intermec

recommendations. Example: The cutter is enabled, (<SI>c1) and the printer

prints a quantity of 5. The job is native, and the printer cuts after each label. The

only way to enable the cutter to cut after a certain number of labels is to either:

Set [INT44xx]CutImmediate=0

Use custom command of <SI>c1 in the PSOs.

Using #2 and unchecking Force Extended should allow the cutter to cut after the

print job.

Custom

Command

The custom command field allow you to enter and send label commands otherwise not

available in the Loftware Label Manager dialog boxes.This command is sent to the

printer regardless of the state of the Printer Specific Option Custom Command.

Use Label

Specific

Options Cut

Interval

Enabling this feature disables any cutting options enabled in the Printer Options section

under Label Handling. All cutter system information is overridden and stored directly in

the label format.

Use Direct

Graphics

Enables Direct Graphics mode on printers that support this option. The download time

of the image is reduced, but images are sent for each label. This eliminates the graphic

size limitations that are normally encountered when storing graphics in non-volatile

RAM. The only size limitation when using direct graphics is the amount of memory

installed on the printer.

Use Direct Graphics is selected by default.

Loftware LabelManager Version 10.1.1 User's Guide

427

1 2 ... 422 423 424 425 426 427 428 429 430 431 432 ... 531 532

Comentários a estes Manuais

Sem comentários

AMT Datasouth Fastmark M1 Guia do Utilizador Página 427

Comentários a estes Manuais