AMT Datasouth Fastmark M1 Guia do Utilizador descarregar pdf (Página 414)

Supported Printers and Drivers

Many of the settings in the printer do not take effect until the printer is re-booted.In the Device Options

dialog box, clicking Send To Printer sends the currently selected options to the printer.All Label Options

are sent to the printer every time a label is printed.

Eltron Options

Eltron Options may be label-specific or printer-specific.

Eltron Label Specific Options

Label Specific Options (LSOs) can be accessed when you click the Label Options from the Label Setup

and Properties dialog (F5).

Label Options Section

Print Speed

The range of available print speeds varies with the selected printer type. This setting controls the

speed at which the paper is fed when printing. The combinations of print speed and head

temperature control the print quality of the label.

Direction

This setting affects the orientation at which the label is printed. The Eltron printers can internally

rotate the label 180 degrees. When Top is selected, the printer begins printing at the top of the label.

When bottom is selected, the label is rotated 180 degrees and printing begins at the bottom.

Head

Temperatu

Allows you to control the darkness of the print. 5 is nominal, setting the temperature higher than 5

causes the label to print darker. Setting the temperature to lower than 5 causes the label to print

lighter. Values from 0 to 7 for 2122/2142 and 0 to 15 for 2242/2044/2046/2642.

Form

Number

Eltron printers have the ability to store multiple forms in memory. In order to store multiple forms, a

unique name must be generated for each form. This option is used to provide a unique form name.

WARNING! Printing Blank Labels? In some instances while printing labels in thermal transfer mode, blank

labels advance out of the printer. If this happens, try increasing the head temperature in Label Specific Options

(F5) and test print your label again. This symptom may occur if the ribbon being used requires hotter head

temperatures to transfer the ink from the ribbon onto the paper substrate.

Label Cut Options Section

Cutter

Use Printer Cut Options uses Cut Options set in the Printer Specific Options section.When enabled, an

optional label cutter is set to cut a label after printing using settings specified in this dialog.

Cut

Every

Allows the cutter to skip a given quantity of labels before cutting.

Cut

Positio

This command is sent to a printer to provide precise cut placement. The default is 100 dpi.

Custom EPL

Command

Field

You can enter printer commands otherwise not available in the Loftware Label Manager

dialog boxes.

Loftware Label Manager Version 10.1.1 User's Guide

414

1 2 ... 409 410 411 412 413 414 415 416 417 418 419 ... 531 532

Comentários a estes Manuais

Sem comentários

AMT Datasouth Fastmark M1 Guia do Utilizador Página 414

Comentários a estes Manuais